The aim of the study is to determine the mercury content in hard coal, randomly taken from the USCB and in by-products of hard coal mining (fresh mining waste), i.e. aggregates (gangue) and hard coal sludge and mining waste from the Siersza dump (weathered waste). The 34 samples were intended for analysis. The total mercury content and the amount of mercury leaching from solid samples was determined. The percentage of the leaching form in the total element content, i.e. the level of mercury release from the material (leaching level), was also calculated. The amount of mercury leaching was determined by a static method using a batch test 1:10. The highest possibility of leaching mercury is characterized by weathered waste from the Siersza dump and slightly lower analyzed hard coal from the U pper Silesian Coal Basin (USCB). For hard coal samples, the total mercury content is between 0.0275–0.1236 mg/kg. However, the amount of mercury leaching from coal samples is 0.0008–0.0077 mg/kg. The aggregate is characterized by a higher total mercury content in the finest fraction 0–6 mm, within 0.1377–0.6107 mg/kg and much lower in the 80-120 mm fraction, within 0.0508–0.1274 mg/kg. The amount of elution is comparable in both fractions and amounts to 0.0008–0.0057 mg/kg. Coal sludge has a total mercury content of 0.0937–0.2047 mg/kg. L ow leaching values of 0.0014–0.0074 mg/ kg are also observed. Weathered mining waste has a total mercury content of 0.0622–0.2987 mg/kg. However, leaching values from weathered waste are much higher than from fresh mining waste. This value is 0.0058–0.0165 mg/kg. In the hard coal extracted from U SCB, the leaching level is 4.7% on average. Mining waste is characterized by a large variation in the proportion of mercury leaching form and the differences result from the seasoning time of the samples. Waste or by-products of hard coal production, such as aggregates and coal sludge, show a mercury washout form at an average level of 1.7%. The proportion of leachable form in weathered waste increased strongly to 7.3%. Elution characteristics vary for different groups of materials tested. Factors such as the type and origin of samples, their granulometric composition and the seasoning time of the material are of fundamental importance and demonstrated in the work.
Contemporary school is exposed to a number of tensions and conflicts arising from the difference in expectations of everyday interactions. in particular, this can manifest itself in difficult situations for which shall be the student's social maladjustment or a threat to social maladjustment, because the multiplicity of involved actors can express different beliefs about the same substance and procedure changes desired and their effectiveness. The solution thus understood the conflict of expectations may be an institutional alliance, instead too far-reaching assumptions about the collaboration.
The paper presents a proposal for the assessment of the reliability of steel truss (both statically determinate and indeterminate) in the persistent and accidental design situation. In the analysis, a probabilistic approach was used. The global Hasofer-Lind reliability index was employed, computed in successive time steps for the whole structure, not for individual elements. The statically determinate truss was modelled as a serial system from the reliability standpoint. For the statically indeterminate truss, kinematically admissible failure mechanisms were determined by means of the examination of the singularity of the stiffness matrix of the structure, converting the truss into a geometrically variable system. For the problem thus formulated, a serial-parallel reliability model was constructed. Monitoring the reliability index in the successive minutes of the fire makes it possible to estimate the probability of the structure failure, and to decide whether the required safety level is maintained.
The article presents a synthetic analysis of the crude oil market in Poland. As of today, this safety is provided mainly on the basis of native lignite and hard coal resources. However, the analysis of the hard coal market conducted by the authors indicates that the carried out mining restructuring (among others) led to an excessive reduction of mining volume and employment level in the hard coal mining sector. This led to a precedent situation when Poland became an importer of this energy carrier. In addition, the European Union’s requirements for greenhouse gas emissions must be taken into account. In connection with the above, it is necessary to search for new energy sources or technologies that enable hard coal to meet the requirements. It is possible to apply the so-called clean coal technologies that allow the greenhouse gas emissions generated during coal combustion to be reduced. As of today, they are not used on a mass scale, because the use of this type of technology involves additional financial expenses. However, taking into account that technologies have been growing faster and faster, are modernized in a shorter time, making a breakthrough discovery took hundreds of years, now it is often a few months, clean coal technologies can become the optimal solution in the near future. It is also necessary to diversify the sources of obtaining imported energy carriers.
The article describes coal and crude oil in terms of their mutual substitution. The article is a continuation of research conducted by the authors. Previous publications presented considerations on analogous topics related to natural gas and renewable energy sources. The crude oil market in Poland was analyzed and forecasts for oil extraction and the demand in the world and Poland by 2023 were presented. The SARIMA model was also created. The model made it possible to obtain oil an prices forecast.
The article examines the trends in the development of renewable energy in Ukraine in accordance
with the long-term strategy of the energy sector of the state in the context of the transformation
of employment in the energy sector of the country. It is emphasized that investments in renewable
energy technologies create more jobs compared to traditional electricity generation technologies.
It is defined that in Ukraine there is a significant untapped potential for energy efficiency, which
requires accelerating the pace of modernization and development of renewable energy sources and
raises the issue of labor supply to the industry. It was emphasized that there are a number of opportunities
for the development of the energy sector of Ukraine related to the development of renewable
energy sources. It is underlined that the formation of territorial-industrial clusters in Ukraine
for the production of equipment for solar and wind energy with a closed production cycle forms
long-term prerequisites for socio-economic stability in the country and stimulates employment. It is
substantiated that an important reserve for increasing employment in Ukraine is to ensure the energy
efficiency of buildings. At the same time, it was noted that in the field of renewable energy and
energy efficiency in Ukraine there is a significant shortage of qualified technicians and specialists
in the field of innovative technologies, which confirms the importance of studying the problem of
labor support in the industry. It is determined that today the solution of the issue of labor supply
of the industry takes place mainly at the level of enterprises that invest in the development of their
own staff.