This paper discussed the effect of the addition of silica fume (2 wt.% and 4 wt.%) and alumina (2 wt.% and 4 wt.%) on the properties of fly ash geopolymer concrete. The fly ash geopolymer concrete achieved the highest 28-day compressive strength with 2 wt.% of silica fume (39 MPa) and 4 wt.% of alumina (41 MPa). The addition of 2 wt.% of silica fume increased the compressive strength by 105% with respect to the reference geopolymer (without additive). On the other hand, the compressive strength surged by 115% with 4 wt.% of alumina compared to the reference geopolymer. The addition of additives improved the compactness of the geopolymer matrix according to the morphology analysis.

In this study, a SYBR Green-based real-time quantitative polymerase chain reaction (qPCR) assay was developed for rapid detection of porcine parvovirus (PPV) 6. Primer pairs targeting the conserved regions of PPV6 Capsid gene were designed. Sensitivity analyses revealed the lowest detection limit of the SYBR Green-based real-time PCR assay to be 47.8 copies/μL, which indicated it was 1000 times higher than that found in the conventional PCR investigations. This assay was specific and showed no cross-species amplification with other six porcine viruses. The assay demonstrated high repeatability and reproducibility; the intra- and inter-assay coefficients of variation were 0.79% and 0.42%, respectively. The positive detection rates of 180 clinical samples with SYBR Green-based real-time PCR and conventional PCR were 12.22% (22/180) and 4.44% (8/180), respectively. Our method is sensitive, specific, and reproducible. The use of SYBR Green-based real-time PCR may be suitable for the clinical detection and epidemiological investigation of PPV6.

The paper describes a research on assessing the quality of edges resulting from the interaction of laser pulses with a material of rigid and flexible printed circuits. A modern Nd:YVO4 crystal diode-pumped solid-state laser generating a 532 nm wavelength radiation with a nanosecond pulse time was used for the research. Influence of laser parameters such as beam power and pulse repetition frequency on a heat affected zone and carbonization was investigated. Quality and morphology of laser-cut substrates were analyzed by optical microscopy. High quality laser cutting of printed circuit board substrates was obtained without delamination and surface damage, with a minimal carbonization and heat affected zone. The developed process was implemented on the printed circuit assembly line.