The present study was conducted to evaluate the insecticidal efficiency and safety of zinc oxide nanoparticles (ZnO NPs) and hydrophilic silica nanoparticles (SiO2 NPs) against: adults of rice weevil (Sitophilus oryzae L.); red flour beetle (Tribolium castaneum Herbst.) and cowpea beetle (Callosobruchus maculatus F.) results showed that, both ZnO NPs and hydrophilic SiO2 NPs exhibited a significant toxic effect (df, F and p < 0.5) against S. oryzae and C. maculatus at the highest concentration while T. castaneum showed high resistance against the two tested materials. At the end of the experiment, recorded mortality was: 81.6, 98.3 and 58.3% at the highest concentration used for each insect (0.3, 2 and 8 gm ⋅ kg–1 of SNPs with C. maculatus, S. oryzae and T. castaneum, respectively), while mortality was 88.3, 100 and 38.3% at the highest concentration used for each insect (0.6, 2.5 and 8 gm ⋅ kg–1 of ZnO NPs with C. maculatus, S. oryzae and T. castaneum, respectively). Both tested materials caused high reductions in F1-progeny (%) with C. maculatus and S. oryzae. Histopathological examination of male mice livers showed hepatic architecture with congested blood sinusoids, binucleated hepatocytes nuclei, dilated central vein and margainated chromatin in some nuclei. Histopathological assessment of the lungs showed normal histoarchitecture. There were no differences in alveolar septa, bronchiolar and epithelium of the treated and untreated animals. Silica and zinc oxide nanoparticles have a good potential to be used as stored seed protectant alternatives if applied with proper safety precautions.
Under former maritime legislation, breaching the regulations established by this legislation was considered a crime or a misdemeanor. The punishment for the latter was usually a money fine. From 1991, this kind of action was punishable by so-called financial penalties, imposed by administrative decision (in administrative procedure) by the local organs of the maritime administration. The present normalization of this material raises a host o f objections. This article discusses this process o f normalization, and casts doubt upon its legality and constitutionality.
In this study, it was achieved by using the method of impulse noise to detect internal or surface cracks that can occur in the production of ceramic plates. Ceramic materials are often used in the industry, especially as kitchenware and in areas such as the construction sector. Many different methods are used in the quality assurance processes of ceramic materials. In this study, the impact noise method was examined. This method is a test technique that was not used in applications. The method is presented as an examination technique based on whether there is a deformation on the material according to the sound coming from it as a result of a plastic bit hammer impact on the ceramic material. The application of the study was performed on plates made of ceramic materials. Here, it was made with the same type of model plates manufactured from the same material. The noise that would occur as a result of the impact applied on a point determined on the materials to be tested has been examined by the method of time-frequency analysis. The method applied gives pretty good results for distinguishing ceramic plates in good condition from those which are cracked.