Abstract
Sealing is an important prerequisite for downhole heater work. This paper proposes a combination of soft and hard and welding sealing programs, which were analyzed using theoretical calculations, numerical simulation, and in-situ testing. The results show that 316 stainless steel can meet the stuffing seal requirements; The first stuffing compresses and gradually reduces, while the second stuffing essentially does not deform. Stuffing deformation to fill the gap in the sealing hole, resulting in a sealing layer. The compression rate is 0.43%, 8.45%, and 12.64%, indicating that the locking stress should be more than 2000 N; The temperature at the weld is heated by heat conduction and distributed in a concentric circle. Thermal stress will influence the 50mm barrier, but the 100mm boundary will be mostly unaffected. Actually, the thermal stress that destroys the weld seal may be reduced by adjusting the heater's output or raising the gas injection rate. During the beginning of the in-situ heat injection, the temperature of the heating rods rises simultaneously with the outlet temperature. As consequently, the two show opposite tendencies. The heat generated by the heating rods will cause the injected gas to be preheated in advance.
Go to article