Signal attenuation caused by the propagation path between the compromising emanation source (the location of secured IT equipment) and the location of the antenna of the potential infiltrating system has a direct influence on the electromagnetic safety of IT equipment. The article presents original analytical relationships necessary to estimate the attenuation values introduced by the propagation path of the potential compromising emanation signal, which correspond to the most probable locations of IT equipment in relation to the location of the potential infiltrating system. The author of the article analyzes various location scenarios for IT equipment – a potential source of compromising emanations – with a potential infiltrating system located either within or outside the boundaries of a building, in which said IT equipment is located. The aforementioned scenarios are characterized by the lowest propagation path attenuation of potential compromising emanation generated by the secured IT equipment and provide for location masking of the potential infiltrating system. Example design of protective solutions for IT equipment elaborated by article author in the form of a shielding enclosure is presented in the article as well.
The existence of inrush current poses a significant problem during the start-up process within three-phase voltage-source rectifiers. To address this problem, this study proposes a strategy to suppress the inrush current effectively based on the virtual-resistor- control method, while preventing the increase in cost of the system and complexity of the algorithm. First, a mathematical model is established based on the dq coordinate frame, and the primary cause of the inrush current is analyzed. Then, the design process of the virtual-resistor-control method is detailed. Finally, the accuracy and effectiveness of the proposed method are verified by simulations and experiments. The results show that the inrush current can be more than two times the rated current before the addition of the virtual resistor. The start-up process can be realized without the inrush current after the addition of the virtual resistor, it does not need to increase hardware costs, there is no secondary inrush current, and the sensitivity of the parameters and the complexity of control are low.
Power big data contains a lot of information related to equipment fault. The analysis and processing of power big data can realize fault diagnosis. This study mainly analyzed the application of association rules in power big data processing. Firstly, the association rules and the Apriori algorithm were introduced. Then, aiming at the shortage of the Apriori algorithm, an IM-Apriori algorithm was designed, and a simulation experiment was carried out. The results showed that the IM-Apriori algorithm had a significant advantage over the Apriori algorithm in the running time. When the number of transactions was 100 000, the running of the IM-Apriori algorithm was 38.42% faster than that of the Apriori algorithm. The IM-Apriori algorithm was little affected by the value of supportmin. Compared with the Extreme Learning Machine (ELM), the IM-Apriori algorithm had better accuracy. The experimental results show the effectiveness of the IM-Apriori algorithm in fault diagnosis, and it can be further promoted and applied in power grid equipment.
As one of the key techniques in the fully mechanized mining process, equipment selection and matching has a great effect on security, production and efficiency. The selection and matching of fully mechanized mining equipment in thin coal seam are restricted by many factors. In fully mechanized mining (FMM) faced in thin coal seams (TCS), to counter the problems existing in equipment selection, such as many the parameters concerned and low automation, an expert system (ES) of equipment selection for fully mechanized mining longwall face was established. A database for the equipment selection and matching expert system in thin coal seam, fully mechanized mining face has been established. Meanwhile, a decision-making software matching the ES was developed. Based on several real world examples, the reliability and technical risks of the results from the ES was discussed. Compared with the field applications, the shearer selection from the ES is reliable. However, some small deviations existed in the hydraulic support and scraper conveyor selection. Then, the ES was further improved. As a result, equipment selection in fully mechanized mining longwall face called 4301 in the Liangshuijing coal mine was carried out by the improved ES. Equipment selection results of the interface in the improved ES is consistent with the design proposal of the 4301 FMM working face. The reliability of the improved ES can meet the requirements of the engineering. It promotes the intelligent and efficient mining of coal resources in China.