Ground penetrating radar (GPR) is one of the most useful non-destructive techniques for locating underground objects. Advancements in this technology have facilitated the development of new sensors over the past decade. In this paper, an accuracy assessment of the location of underground objects using various GPR antennas is presented. To achieve the stated goals, measurements of 5 concrete slabs, reinforced with steel bars of various diameters and located at variable depths were taken. The experiment includes the usage of three GPR antennas to assess the format, characteristics, and differences of extracted data. This set of antennas from different manufacturers varied in terms of operating frequency. Additional lidar data from TLS (terrestrial laser scanning) was utilized in the methodology to provide precise surface measurements and therefore, external orientation of the surveyed data. The experiment allowed for the determination of vertical and horizontal accuracy for three tested antennas and the assessment of increasing errors value with greater depth of the measured items, which is important for surveying accuracy forecasting.

Rubberized concrete is made up of scrap tyre rubbers where the fine aggregate is partially replaced by it, as the waste rubber is being a threat to the environment. It is estimated that only 4% of the waste tyre is used in the application of civil engineering and also there is shortage of fine aggregates. The primary objective of this study is to investigate the preliminary concrete properties of M25 and M30 concretes. The fine aggregate is replaced by pre-treated crumb rubber with 10, 15 and 20 % of total weight. Various tests are conducted on the rubberized concrete specimens such as compressive strength, split tensile strength, flexural strength and slump test. The investigation is carried out to determine the impact load behavior of hybrid rubberized composite slabs. In addition 0%, 1%, 1.5%, and 2% of replacement of rubber fibers for total weight of coarse aggregate is also made. The specimen of size 300 mm x 300 mm x 50 mm thickness is subjected to drop hammer test to find its performance against the impact loads. The number of blows for the first crack and complete failure of slab was found and the characteristics were studied.