The paper presents test results for the assessment of the tracer content in a three-component (green peas, sorghum, maize) feed mixture that is based on the fluorescent method. The homogeneity of mixtures was determined on the basis of the maize content (as the key component), which was treated with fluorescent substance: tinopal, rhodamine B, uranine and eosin. The key components were wet-treated with fluorescent substances with different concentrations. Feed components were mixed in a vertical funnel-flow mixer. 10 samples were collected from each mixed batch. Samples were placed in a chamber equipped with UV light and, then, an image recorded as BMP file was generated. The image was analysed by means of the software programme Patan. On the basis of the analyses conducted, data on the maize content marked with a fluorescent marker were obtained. Additionally, the content of the key component was determined in a conventional manner – using an analytical scale. Results indicate the possibility of using this method for homogeneity assessment of the three-component grain mixture. From these tests, fluorescent substances that can be applied in the case of maize as a key component, together with their minimum concentrations, were identified: tinopal 0.3%, rhodamine B 0.001%.
In the present investigation optical, electro-optical and dielectric properties have been measured for nematic liquid crystal (NLC) material 1550C which consists of 4’-(trans, trans-4-alkylbicyclohexyl) carbonates and 4’-(4-(trans,trans-4-alkyl)-4-cyanobicyclohexane, dispersed with fluorescent dye (Benzo 2,1,3 Thiadiazole) in two different concentrations. Photoluminescence has been enhanced for a dye dispersed system which is the key finding of this investigation. UV absorbance study has also been performed and found to be increased for composite system. Enhanced birefringence after dispersion of dye into pure NLC is also a prominent result of this investigation. Relative permittivity, threshold voltage and dielectric anisotropy have also been measured and found to be increased. The outcome of the present work may be very useful in the construction of liquid crystal displays (LCDs).
The subject of this work was the investigation of zeolite as a sorbent of toxic gases. In Nizny Hrabovec in the Slovak republic, two layers of zeolite with the active component clinoptilolite can be found. The study presented here investigated the ability of this natural zeolite to reduce polycyclic aromatic hydrocarbons (PAH) and NO emissions from engine exhaust. Exhaust gases from combustion engines include toxic components such as carbon monoxide, nitrogen oxides and hydrocarbons. Polycyclic aromatic hydrocarbons (PAH) are a component of hydrocarbons causing harmful influence on life forms. The experiments focused on the potential reduction of these toxic gases based on the sorption and catalytic properties of natural zeolite. Also observed was the influence of chemical adjustment including incorporation of certain metal elements. Chemical analysis by mutually independent technologies served to observe the sorption of PAH with carcinogenic properties on the natural zeolite tested. The experiments showed that chemical modification improved the sorption and catalytic properties of natural zeolite. The PAH were analysed in an extract of the contaminated, thermally-activated natural zeolite and modified zeolite after washing with ammonium chloride, cobalt chloride and copper sulphate. The study also presents results of NO measurements obtained by testing the filter-sorptive automobile system.
This article is focused on considerations based on experimental studies concerning changes of selected parameters of identical compact fluorescent lamps (CFLs) intended for use in buildings during their operation. The studies constituted a long-term experiment whose goal was an evaluation of selected operating parameters of the CFLs in terms of meeting the requirements set out in the specified regulations as well as the issue of marking the lamps with the energy efficiency class. The measurements were performed with the authors’ experimental setup consisting of original equipment designed and made especially for the purpose of the measurements. The studies covered registration of the luminous flux as well as selected electrical parameters such as active power, current and the power factor during the so-called “start-up time” and operation time equal to 100 h, 500 h, 1000 h, 2000 h, etc. with a 1000 h step. The studies were finished with the moment of natural burnout of the CFLs tested. The results showed that the biggest drawback of CFLs is lack of preservation of the required time to reach 60% of the stabilized luminous flux just after short time of lamp operation. Similarly when assessing the conformity of the parameters declared by the manufacturer that have been verified, it can be stated that they are true only at the initial stage of lamp operation.
This article is focused on considerations based on experimental studies concerning changes of selected parameters of identical compact fluorescent lamps (CFLs) intended for use in buildings during their operation. The studies constituted a long-term experiment whose goal was an evaluation of selected operating parameters of the CFLs in terms of meeting the requirements set out in the specified regulations as well as the issue of marking the lamps with the energy efficiency class. The measurements were performed with the authors’ experimental setup consisting of original equipment designed and made especially for the purpose of the measurements. The studies covered registration of the luminous flux as well as selected electrical parameters such as active power, current and the power factor during the so-called “start-up time” and operation time equal to 100 h, 500 h, 1000 h, 2000 h, etc. with a 1000 h step. The studies were finished with the moment of natural burnout of the CFLs tested. The results showed that the biggest drawback of CFLs is lack of preservation of the required time to reach 60% of the stabilized luminous flux just after short time of lamp operation. Similarly when assessing the conformity of the parameters declared by the manufacturer that have been verified, it can be stated that they are true only at the initial stage of lamp operation.
Using Langmuir and Langmuir-Blodgett techniques molecular films of chlorinated perylene derivatives, namely tetra-n-butyl-1,6,7,12-tetrachloroperylene-3,4,9,10-tetracarboxylate (PCn for n = 1, 5, 9) have been studied. The Langmuir films of pure compounds and mixed with liquid crystalline 4-octyl-4′-cyanobiphenyl (8CB) were characterized by surface pressure-mean molecular area isotherms. An additive rule reveals miscibility of all the dyes with 8CB but shows different types of intermolecular interaction forces. The pure and mixed Langmuir films were transferred onto quartz plates and characterized spectroscopically. Absorption and fluorescence spectra were recorded for the samples in form of diluted chloroform solution, the dye with 8CB mixtures in monomolecular Langmuir-Blodgett films and in liquid crystal cells. Different tendency to aggregation of the dye with short and long alkyl chains was observed. It is shown that the dye molecule stacking and aggregation of the chlorinated perylene dyes depend on the dye concentration and are related to the torsion of the perylene core.
In this work a review of investigations concerning interaction of intense extreme ultraviolet (EUV) and soft X-ray (SXR) pulses with matter is presented. The investigations were performed using laser-produced plasma (LPP) EUV/SXR sources based on a double stream gas puff target. The sources are equipped with dedicated collectors allowing for efficient focusing of the EUV/SXR radiation pulses. Intense radiation in a wide spectral range, as well as a quasi-monochromatic radiation can be produced. In the paper different kinds of LPP EUV/SXR sources developed in the Institute of Optoelectronics, Military University of Technology are described.
Radiation intensities delivered by the sources are sufficient for different kinds of interaction experiments including EUV/SXR induced ablation, surface treatment, EUV fluorescence or photoionized plasma creation. A brief review of the main results concerning this kind of experiments performed by author of the paper are presented. However, since the LPP sources cannot compete with large scale X-ray sources like synchrotrons, free electron lasers or high energy density plasma sources, it was indicated that some investigations not requiring extreme irradiation parameters can be performed using the small scale installations. Some results, especially concerning low temperature photoionized plasmas are very unique and could be hardly obtained using the large facilities.
To study the influence of structural features of phthalocyanine (Pc) derivatives on their physico-chemical properties in bulk and thin films, 23 new phthalocyanines with different quantity and ratio of donor (alkyloxy-groups, in fragment “A”) and acceptor (Cl-, in fragment “B”) substituents in one molecule of the A3B, ABAB and AABB types with varied length of alkyloxy-substituents and their metal complexes were designed and synthesized. A comparative analysis of spectral, mesomorphic and photoelectric properties of these mix-substituted phthalocyanines of a “push–pull” type was performed. It was shown that non-peripheral substitution by alkyloxy-fragments in hetero-substituted Pcs (similar to homo-substituted Pc) leads to red-shifting of the Q-band into near-IR region. The intensity of photoluminescence, position of peaks and their splitting are strongly connected with chemical structure of Pcs and the type of solvent. In contrast to non-mesogenic octyloxy-Pc (A4) having alkyloxy-substituents in non-peripheral positions, 22 of 23 synthesized compounds possess columnar mesomorphism. The change of donor–acceptor ratio can influence the type of mesophase. A new approach to the creation of materials for optoelectronics is proposed and implemented, which includes design of compounds possessing vitrification from mesophase with maintenance of a columnar order, absorption in the near IR-region of the spectrum and good performance electrophysical characteristics simultaneously.