Search results

Filters

  • Journals
  • Authors
  • Keywords
  • Date
  • Type

Search results

Number of results: 3
items per page: 25 50 75
Sort by:
Download PDF Download RIS Download Bibtex

Abstract

Hybrid Renewable Energy Systems connected to the traditional power suppliers are an interesting technological solution in the field of energy engineering and the integration of renewable systems with other energy systems can significantly increase in energy reliability. In this paper, an analysis and optimization of the hybrid energy system, which uses photovoltaic modules and wind turbines components connected to the grid, is presented. The system components are optimized using two objectives criteria: economic and environmental. The optimization has been performed based on the experimental data acquired for the whole year. Results showed the optimal configuration for the hybrid system based on economical objective, that presents the best compromise between the number of components and total efficiency. This achieved the lowest cost of energy but with relatively high CO2 emissions, while environmental objective results with lower CO2 emissions and higher cost of energy and presents the best compromise between the number of components and system net present cost. It has been shown that a hybrid system can be optimized in such a way that CO2 emission is maximally reduced and – separately – in terms of reducing the cost. However, the study shows that these two criteria cannot be optimized at the same time. Reducing the system cost increase CO2 emission and enhancing ecological effect makes the system cost larger. However, depends on strategies, a balance between different optimization criteria can be found. Regardless of the strategy used economic criteria – which also indirect takes environmental aspects as a cost of penalties – should be considered as a major criterion of optimization while the other objectives including environmental objectives are less important.

Go to article

Authors and Affiliations

Patryk Palej
Hassan Qusay
Sławosz Kleszcz
Robert Hanus
Marek Jaszczur
Download PDF Download RIS Download Bibtex

Abstract

The overriding objective of the National Electric Power System (KSE) is to ensure the security of electricity supply. In summer, the upward trend in the demand for electric energy is caused by, among others, the proliferation of air conditioners. Therefore, the upward trend in summer’s on-peak demand is expected to be maintained. Examples from 2015, 2016 or 2018 indicate that National Electric Power System needs a summer’s on-peak source that will be able to produce electricity regardless of the hydrological conditions. Photovoltaics is a source of energy that can cover the peak demand during sweltering heat. This article briefly characterizes the problem of increasing demand for electricity in summer and uses examples that have taken place in recent years. The main conclusion is the postulate for the extension of photovoltaic power in the National Electric Power System, the purpose of which will be the production of electricity during sweltering heat, covering the peak load in the system. This article presented both the advantages and disadvantages of such a solution. Unfavorable weather conditions (high air temperature, low water level, lack of wind) limit the production of electricity from wind farms or conventional power plants, and also increase transmission losses, which is why photovoltaics is a desirable source from the National Electric Power System’s point of view. The article refers to examples from the Czech Republic and Germany, where a significant installed capacity of photovoltaics enables the stable operation of the power system during sweltering heat. It was also pointed out that the role of photovoltaics in the National Electric Power System is growing, which is consistent with the assumptions of the Polish Energy Policy Project until 2040.

Go to article

Authors and Affiliations

Bartosz Sobik
Download PDF Download RIS Download Bibtex

Abstract

Solar photovoltaic (PV) and concentrated solar power (CSP) systems are the present worldwide trends in utilizing solar energy for electricity generation. Solar energy produced from photovoltaic cells (PV) is considered the main common technology used due to its low capital cost; however, the relatively low efficiency of PV cells has spotlighted development and research on thermal engine applications using concentrated solar power. The efficiency of concentrated solar power is greater than that of PV and considering the solar potential for Sudan. Therefore, this study has been performed in an attempt to draw attention to the utilization of CSP in Sudan since the share of CSP is insignificant in comparison with PV, besides the suitability of CSP applications to Sudan’s hot climate and the high solar energy resource, the study presents a design model of 1 MW parabolic trough collectors (PTC) using the Rankine cycle with thermal energy storage (TES) in Sudan, by adopting reference values of the Gurgaon PTC power plant in India. The design of a 1 MW Concentrated Solar thermal power plant using parabolic trough collectors (PTC) and thermal energy storage is proposed. The simulation was performed for a site receiving an annual direct normal irradiance (DNI) of 1915 kWh/m2, near Khartoum. The results showed that the plant can produce between nearly 0.6 to 1 MWh during the year, and around 0.9 MWh when it encompasses thermal energy storage with an average thermal efficiency of 24%. These results of the PTC Power plant encourage further investigation and the development of CSP technologies for electricity generation in Sudan.
Go to article

Authors and Affiliations

Abdelkareem Abdallah Abdelkareem Jebreel
1
ORCID: ORCID
Hamad Mohamed Ali Hamad
2

  1. Sapienza Università di Roma, Italy
  2. University of Khartoum, Sudan

This page uses 'cookies'. Learn more